Diagnostic
Heat pump running but not heating
The fan runs, the controller shows a demand, but the water stays cold.
Heat pumps fail in a small number of predictable ways. Low water flow, a failed flow switch, an iced evaporator or a refrigerant fault account for most of the calls we attend.
The usual causes
Low water flow
A dirty filter, blocked bypass or failing pump starves the heat exchanger and the unit protects itself.
Failed flow or pressure switch
The unit believes there is no flow and refuses to start the compressor.
Iced evaporator
Cold, humid air and poor airflow cause repeated defrost cycles and long recovery times.
Refrigerant leak
Heating capacity fades gradually until the unit runs constantly without raising temperature.
Sensor or controller fault
A faulty water sensor reports the set point as reached, so the unit never runs.
What you can check
- —Check the pool or system filter and the bypass setting
- —Confirm the fan is running and the coil is not iced
- —Compare the displayed water temperature with a separate reading
- —Note any error code before calling
Where it is covered
This fault is handled under heat pump installation & repairs. If the equipment is down and stock or guests are at risk, call 012 546 5996 rather than waiting on a form.