Diagnostic

Compressor tripping the circuit breaker

The unit starts, then trips the supply, sometimes after a few seconds.

A breaker that trips on start is protecting the circuit from a fault. The cause can be as simple as a failed capacitor or as serious as a seized compressor, so repeated resetting is the worst thing to do.

The usual causes

01

Failed start capacitor or relay

The compressor draws locked-rotor current and trips the breaker within seconds.

02

Undersized or shared circuit

A unit added to a circuit that was never designed for it will trip under start-up load.

03

Earthing or insulation fault

Moisture or corrosion in the electrical enclosure causes a leakage current that trips protection.

04

Seized or failing compressor

Mechanical failure draws excessive current. This is the outcome that most justifies prompt attention.

What you can check

  • —Do not keep resetting the breaker
  • —Switch the unit off at the isolator
  • —Note whether the trip happens immediately or after running
  • —Have the supply and start components tested before replacing the compressor

This fault is handled under emergency refrigeration repairs. If the equipment is down and stock or guests are at risk, call 012 546 5996 rather than waiting on a form.

CallWhatsAppEnquire