Diagnostic
Chiller running with low capacity
The plant runs continuously, but chilled water never reaches design temperature.
A chiller that runs without delivering capacity is usually losing heat rejection or water flow. Both are measurable, which means the diagnosis does not have to be guesswork.
The usual causes
Fouled condenser
Salt, dust and debris insulate the coil, raising condensing pressure and cutting capacity.
Low refrigerant charge
A leak reduces the effective refrigerant in circulation, so the evaporator is starved.
Reduced chilled-water flow
A failing pump, blocked strainer or partly closed valve lowers the temperature differential the plant can achieve.
Control or sensor drift
A sensor reading incorrectly can make a healthy chiller appear to underperform, or prevent loading.
Plant room overheating
Poor ventilation raises the air temperature around an air-cooled condenser and reduces capacity.
What you can check
- —Record entering and leaving water temperatures
- —Check the condenser for visible blockage
- —Confirm pumps are running and strainers are clean
- —Note any alarms and when they started
Where it is covered
This fault is handled under chiller installation & maintenance. If the equipment is down and stock or guests are at risk, call 012 546 5996 rather than waiting on a form.